Electro-Voice PL35 - Manual (Page 2)

Microphone Use and Placement
Please note that micing techniques are a matter of personal
preference. These are merely guidelines to assist in the
placement of the microphone to gain optimal performance.
Usage Optimal Placement
Electric Guitar and
Bass Guitar Amplifier
Place microphone approximately 1 to 2 inches from and at a 90° angle to the speaker cone. To reduce
boominess, move the microphone off axis to the cone from 90° to 45°, or move mic from center of cone to
either edge.
Tom-Toms On double headed Toms, place mic 1 to 3 inches over the top of drum, at a 45° angle to the drum surface,
and 1 to 2 inches in from the drum edge. On single headed Toms, use above method or place mic inside
Tom from underneath at a 90° angle from the center of head, 3 to 5 inches away.
Snare Drum Place mic 1 to 3 inches above the top head, 1 to 2 inches in from the rim. Aim the mic downward at an
angle toward the top head. If the drum rings, tape deadening material to the head or use damping rings.
For more “snare” sound, place a 2nd mic underneath aimed up at the bottom of head.
Cymbals Place mic 1 to 2 feet above the top of cymbals.
High-Hat Place mic 5 inches above outside edge at a 45° down angle.
Brass Place mic 6 to 24 inches away, and on axis with the bell of the instrument.
Acoustic Guitar Place mic 6 to 12 inches from where finger board joins the body.
12000 Portland Avenue South, Burnsville, MN 55337
Phone: 952/884-4051, Fax: 952/884-0043
www.electrovoice.com
© Bosch Communications Systems 08/2008
Part Number LIT000247 Rev B
U.S.A. and Canada only. For customer orders, contact Customer Service at:
800/392-3497 Fax: 800/955-6831
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
+ 49 9421-706 0 Fax: + 49 9421-706 265
Other Internatonal locations. For customer orders, Contact Customer Service at:
+ 1 952 884-4051 Fax: + 1 952 887-9212
For warranty repair or service information, contact the Service Repair department at:
800/685-2606
For technical assistance, contact Technical Support at: 866/78AUDIO
Specifications subject to change without notice.
Electro-Voice ®
Dimension
Drawing:
Frequency Response: Polar Response:
Standard Placement & Use Guidelines
1. Always point the microphone at the desired source of sound, and away from any unwanted sources.
2. The microphone should be located close to the sound source to minimize interference from other potential sound sources.
3. Use the 3-to-1 rule when using multiple microphones. Place each microphone three times farther from other microphones as from
the desired sound source.
4. Minimize over-handling of the microphone to reduce unwanted mechanical noise.
PL35 Part Numbers
PRD000164000 PL35, Dynamic Supercardioid Snare/Tom •
Microphone
ACC000044000 DRC-1, Replacement Clip-on Drum Rim •
Clamp
ACC000050001 WSPL-3, Optional Foam Windscreen, Black •