Enviro EF THERMO 28 CE2005 - Manual (Page 5)

5
W
ARNINGS AND
R
ECOMMENDATIONS
:
A. Do not abuse the glass by striking or slamming the door shut.
B. Do not attempt to operate the stove with broken glass.
C. Do not attempt to open the door and clean the glass while the unit is in operation. To clean the glass,
use a soft cotton cloth and mild window cleaner, gas or wood stove glass cleaner, or take a damp
paper towel and dip into the fly ash. This is a very mild abrasive and will not damage the glass.
D. Do not use abrasive cleaners to clean the surface or any part of the stove.
E. It is recommended that the unit be secured into its position in order to avoid any displacement.
F. Never use gasoline, gasoline-type lantern fuel, kerosene, or similar liquids to start the fire. Keep all
such liquids well away from the pellet stove while it is in use.
G. Disposed ashes should be placed in a metal container with a tight-fitting lid. The closed container of
ashes should be on a non-combustible floor on the ground, well away from all combustible materials
pending final disposal. The ashes should be retained in the closed container until all cinders have
thoroughly cooled before disposing of them.
H. Make sure the ash pan is closed tightly during the operation of the stove.
I. Fresh air intake is strongly recommended. Failure to install intake air may result in the unit smoking
during power failures as well as improper combustion.
J. Do not operate at water pressure below 0.5 bar.
NOTE: Fresh air is mandatory on all units installed in “Mobile Homes” and “Air Tight” homes.
KEEP ASH PAN FREE OF RAW FUEL. DO NOT PLACE UNBURNED OR NEW PELLET FUEL IN
ASH PAN. A fire in the ash pan could be the result.
In the event of a malfunction, turn the water heater feed OFF. Push the ON/OFF button
located on the control panel. Have the water heater inspected and serviced by a qualified
service technician.
- Have your unit and venting checked/cleaned/serviced annually by a qualified service technician
to prevent excess build-up of dangerous creosote deposits as well as to ensure proper
operation and efficiency of this appliance.
IMPORTANT: The heated water from this unit is not for human consumption, but for heating
potable water through heat exchange only.
WARNING: No modifications can be preformed to this appliance prior authorization from the
manufacturer. Use only Enviro approved replacement parts
Introduction
Check the burn-pot liner periodically to ensure that the holes are not blocked with clinkers, (clinkers are
silica in the fuel that form a hard mass during the burning process). If they are blocked, remove the liner
(when the unit is cold) and clean the clinkers out. The liner should be cleaned or scraped once every 2-3
days depending on wood pellet quality. Clean the holes in the liner with a small pointed object.
Store pellets at least 36” (1 m) away from the pellet stove.