Enviro EF THERMO 28 CE2005 - Manual (Page 3)

3
Introduction
I
MPORTANT
S
AFETY
D
ATA
:
Please read this entire manual before installation and use of this pellet fuel burning room heater. Failure
to follow these instructions could result in property damage, bodily injury or even death.
CAUTION: DO NOT CONNECT TO ANY AIR DISTRIBUTION DUCT OR SYSTEM.
DO NOT BURN GARBAGE OR FLAMMABLE FLUIDS SUCH AS GASOLINE, NAPTHA OR
ENGINE OIL.
UNIT HOT WHILE IN OPERATION. KEEP CHILDREN, CLOTHING AND FURNITURE AWAY.
CONTACT MAY CAUSE SKIN BURNS.
Contact local building officials about restrictions and installation inspection requirements in your area.
The stove’s exhaust system works with negative combustion chamber pressure and a slightly positive
chimney pressure. It is very important to ensure that the exhaust system be sealed and airtight.
The use of grates or other methods of supporting the fuel is not permitted.
This unit is designed to burn pelletized wood fuel only. Do not use any other type of fuel, this will void
any warranties stated in this manual.
THE USE OF CORDWOOD IS PROHIBITED BY LAW.
Do not burn with insufficient combustion air. A periodic check is recommended to ensure proper
combustion air is admitted to the combustion chamber. Setting the proper combustion air is achieved by
adjusting the slider/damper located on the left side of the stove.
It is advisable to clean the exhaust vent bi-annually or every two tons of pellets.
The grounded electrical cord should be connected to a standard 220-240 volts, 50 hertz electrical outlet
and also must be accessible. If this power cord should become damaged, a replacement power cord
must be purchased from the manufacturer or a qualified ENVIRO dealer. Be careful that the electrical
cord is not trapped under the appliance and that it is clear of any hot surfaces or sharp edges. This unit’s
maximum power requirement is 800 watts (3.3 amp).
Soot or creosote may accumulate when the stove is operated under incorrect conditions such as an
extremely rich burn (black tipped, lazy orange flames). If the creosote is ignited it will make an extremely
hot fire, therefore, the smoke pipe and chimney should be inspected regularly to determine if a build-up
has occurred. If creosote has accumulated it should be removed to reduce the risk of a chimney fire. If a
fire occurs throw a cup of water into the firebox, close the door, and call the fire department.
When installing the stove in a mobile home, it must be electrically grounded to the steel chassis of the
home and bolted to the floor. Make sure that the structural integrity of the home is maintained and all
construction meets local building codes.
Be sure to maintain the structural integrity of the home when passing a vent through walls, ceilings, or
roofs.
IMPORTANT: The ash pan and viewing door must be locked securely for proper and safe operation of
the pellet stove.
If you have any questions with regards to your stove or the above-mentioned information, please feel
free to contact your local dealer for further clarification and comments.
Since Sherwood Industries Ltd. has no control over the installation of your stove, we grant no warranty
implied or stated for the installation or maintenance of your stove. Therefore, Sherwood Industries Ltd.
assumes no responsibility for any consequential damage.