Ei Electronics Carbon Monoxide Alarm Ei 205EN - Manual (Page 2)

Shannon Free Zone, Shannon, Co. Clare, Ireland.
Ph. +353 61 471277 Fx. +353 61 471053
Email. [email protected]
Web: www.eielectronics.com
E & OE As our policy is one of continuous product development, we reserve the right to alter product details without prior notice . Ei205EN DataSht RevB
Model Ei205EN CO Alarm
Installation & Placement
To mount onto a wall or ceiling, simple remove the battery compartment and mark the position of the two mounting holes.
Drill two holes using a 6mm drill for the plastic plugs (supplied) and screw the unit home with the screws supplied
If locating the CO alarm in a room with an appliance
- the alarm should be located between 1m and 3m horizontally from the appliance and between 1.85m and 3m from the
appliance
- the alarm should be located preferably on the ceiling, at least 300mm from any wall
- if placed on a wall, the CO alarm should be as ahigh as possible but not within 150mm of the ceiling
If locating the CO alarm in a room remote from the appliance
- the alarm should be located at a level similar to the breathing zone of the occupant (typically 1.5m to 2m above floor
level and in bedrooms at the height of the bed)
More specific details are found in the Use & Care Instruction Booklet.
Technical Specification
Sensor Electrochemical sensor
Sensitivity:
Meets BS EN 50291:2001
Button Test: Checks the electronics and horn
Memory Feature
When the test button is pressed
the horn will sound and the red
light will only flash if the unit has
previously detected CO and been
in alarm
Automatic Self-Test: Horn beep and amber fault light
flashes every minute if a fault is
found
Supply Voltage: 3 x 1.5V AA Alkaline battery
Dimensions: 135 x 105 x 71 mm
Weight: 260g
Power-On Indicator: Flashing green LED every minute
Alarm:
Electronic Piezoelectric horn
Alarm Sound Output:
85dB (minimum) at 3m
Alarm Status:
Red LED flashes and horn sounds
Temperature Range:
-5 o to 40 o C
Humidity Range:
15% to 95% Relative Humidity
Interconnect: Up to 12 detectors with Ei205C EN
model only
Fixing: Simple screw fixings
Plastic material: UL94VO flame retardant
Warranty:
2 year warranty
Approvals:
Kitemarked to BS EN 50291:2001
Specifications are subject to change