Electrolux 1051 VI fele - Manual (Page 27)

At the end of the programme
The machine stops automatically and three flashing zeros are displayed.
The END and spin speed pilot lights, as well as the pilot light(s) corre-
sponding to the selected option(s), stay on.
If the RINSE HOLD option has been selected, the corresponding pilot
light on the programme progress display flashes to indicate that the
water must be emptied out before opening the door.
The pilot light of the START button flashes and tree flashing zeros are
displayed.
Release of the lock is indicated by an audible signal.
Switch the machine off by pressing the ON/OFF button.
Turn the programme selector dial to RESET.
Remove the laundry from the drum.
Check that the drum is empty so as to avoid a subsequent wash being
damaged by any forgotten items.
Close the water tap.
Leave the door open to prevent the formation of mildew and unpleas-
ant smells.
27
Selection of the DELAY START option
To delay starting of a programme, press the
DELAY START button before starting the
machine. The figures corresponding to the
selected delay will be displayed for about 2
seconds, after which the duration of the
selected programme will appear on the display.
When the START/PAUSE button is pressed, the selected delay will
again appear on the display and the machine starts its countdown.
Starting the programme
To start the selected programme, press the START/PAUSE
button; the corresponding light stops flashing.
The pilot light corresponding to the wash phase which is
running comes on.
After about 30 seconds the programme starts.
26
How to wash How to wash
START
PAUSE
DELAY
START