Electrolux 1051 VI fele - Manual (Page 16)

Altering a programme which is running
To alter a programme, first set the machine to PAUSE by pressing the
START/PAUSE button.
Before the machine starts the heating phase, i.e. within the first 15
minutes for cotton programmes, 10 minutes for easy-cares and delicate
programmes and 5 minutes for the wool programme, the selected wash
cycle can be modified.
Warning! If the programme selector dial is turned first to RESET and then
to the new programme, the programme which is running is cancelled, the
water is emptied out and the machine re-starts from water filling. To
simply modify the programme which is running, turn the programme
selector dial to the desired position (avoiding the RESET position): when the
START/PAUSE button is pressed again, the machine restarts with the newly
selected programme from the point at which it was interrupted.
Opening the door after the programme has started
The door can only be opened before the machine starts the heating
phase (within the first 15, 10 or 5 minutes, depending on the pro-
gramme selected - see paragraph above) and during the rinse phase.
Set the machine to PAUSE (by pressing the START/PAUSE button).
If the door does not open, this means that the machine is already heat-
ing, or that the water level is above the bottom edge of the door.
This prevents water from spilling out when the door is opened.
17
• delayed start, programmed using the special button (C).
The selected delay (19 hours max.) is indicated in the display. The
countdown is updated every hour, and every 5 minutes during the last
hour.
• Heating phase. A dot to the right of the figures in the display indi-
cates that the machine is heating the water.
• Incorrect option selection. If an option which is not compatible with
the set wash programme is selected, the message Err is displayed.
Programme progress display
By selecting the wash programme, the pilot lights cor-
responding to the various phases making up the pro-
gramme come on.
After the machine has started, only the running phase
pilot light stays on. When the programme has finished,
the END pilot light comes on.
Cancelling a programme
To cancel a programme which is running, turn the programme selector
dial to the RESET position: three flashing dashes will be displayed.
Warning! After a programme which ends with water in the drum
(RINSE HOLD option), turn the selector dial first to RESET and then to
the PUMP OUT programme.
16
Description of the appliance Description of the appliance
PREWASH
WASH
RINSE
RINSE HOLD
SPIN
END
PUMP OUT