Electrolux EHD68200P - Manual (Page 30)

30 electrolux what to do if …
If you are unable to remedy the
problem by following the above
suggestions, please contact your
dealer or the Customer Care De-
partment.
Warning! Repairs to the appliance
are only to be carried out by quali-
fied service engineers. Considera-
ble danger to the user may result
from improper repairs.
If the appliance has been wrongly
operated, the visit from the custom-
er service technician or dealer may
not take place free of charge, even
during the warranty period.
flashes Unsuitable cookware Use suitable cookware
No cookware on the cooking
zone Put cookware on zone
Diameter of the base of the
cookware is too small for the
cooking zone Use suitable cookware (min.
120 mm)
Cookware not completely cov-
ering cross Place cookware centrally over
the cross
is lit Overheating protection for the
cooking zone has been trig-
gered Switch off the cooking zone.
Switch the cooking zone on
again
Safety cut-out has been trig-
gered Switch off the cooking zone.
Switch the cooking zone on
again
and number are displayed Electronics fault Disconnect the appliance from
the electrical supply for a few
minutes (Take the fuse out of
the house’s wiring system)
If after switching on again,
is displayed again, call the
customer service department
Problem Possible cause Remedy