Eagle Electronics FISHEASY 320C User Manual

Page 43

Portable Transducer Assembly
Recommended tools for installation include a slotted screw driver and
two adjustable wrenches.

Assemble the transducer and bracket as shown in the following figure.
Attach the transducer to the bracket with the supplied hardware.

Make sure there is one washer on each side of the transducer, inside
the bracket. Slide the other washer over the end of the bolt and thread
the nut onto it.

Screw the suction cup onto the bracket using the supplied screw and flat
washer. Tie the nylon cord through the hole in the top of the bracket.
When using this transducer, tie the other end of the nylon cord to the boat.
This will help prevent the loss of the transducer if it comes off the boat.

Portable transducer assembly: rear view (left) and side view (right.)

Clean the chosen area of the hull before attaching the suction cup. Lo-
cate the transducer on the hull as shown in the following figure. Don't
allow the bracket to extend below the hull, because water pressure
against it can cause the suction cup to come off at speed.

Washer

Nut

Bolt

Screw

Suction

cup

Transducer

Tie nylon

cord here