Echo PAS-2601 EN User Manual
Page 11
P
RO
A
TTACHMENT
S
ERIES
O
PERATOR
'
S
M
ANUAL
11
1. POWER HEAD - Includes the Engine, Clutch, Fuel System, Ignition System and Recoil Starter.
2. MUFFLER, SPARK ARRESTOR - The muffler controls the exhaust noise while the spark arrestor prevents hot,
glowing particles of carbon from leaving the muffler where they could possibly start a fire.
3. RECOIL STARTER HANDLE - Pull handle slowly until recoil starter engages, then quickly and firmly. When engine
starts, return handle slowly. DO NOT let handle snap back or damage to unit will occur.
4. FUEL TANK - Contains fuel and fuel filter.
5. PRIMER BULB - Before starting and after filling the fuel tank, pump primer bulb 10 times or until a steady stream of
fresh fuel without air is visible through the "clear" fuel return line.
6. FUEL TANK CAP - Covers and seals fuel tank opening.
7. CHOKE - The choke control lever is located on the top of the air cleaner case. Move lever to "COLD START" to
close choke for cold starting. Move lever to the "RUN" position to open choke.
8. AIR CLEANER - Contains replaceable filter element.
9. THROTTLE TRIGGER - Spring loaded to return to idle when released. During acceleration, press trigger gradually for
best operating technique.
10. UPPER DRIVE SHAFT ASSEMBLY - Includes the Rear (Right Hand) Handle Assembly, Front (Left Hand) Handle
Assembly, Flexible Drive Cable, Drive Shaft Assembly Coupler and Power Head.
11. DRIVE SHAFT COUPLER - Includes Locator Pin and Clamping Knob.
12. FRONT HANDLE - The Front Handle must be assembled to the Upper Drive Shaft assembly and positioned for proper
cutting attitude and operator comfort.
13. STOP SWITCH - "SLIDE SWITCH" mounted on top of the Throttle Trigger Housing. Move switch FORWARD to
RUN, BACK to STOP.
14. GRIP - Rear (right hand) handle.
15. SPARK PLUG - Provides spark to ignite fuel mixture.
16. ARM REST - Provides arm rest during operation and protects arm from the hot engine.
17. OPERATOR'S MANUAL - Included in plastic bag (co-pack). Read before operation and keep in a safe place for future
reference, i.e., operation, maintenance, storage and specifications.