beautypg.com

Installation instructions, Electric outlet, Grounding instructions – Cafe 24 Inch Built In Microwave Drawer Oven Installation Guide User Manual

Page 4: Drawer installation

background image

4

31-7000166 Rev. 0

Installation Instructions

ELECTRIC OUTLET

The electrical requirements are a 120 volt 60 Hz, AC

only, 15 amp. or more protected electrical supply. It

is recommended that a separate circuit serving only

this appliance be provided.

The drawer is equipped with a 3-prong grounding

plug. It must be plugged into a wall receptacle that

is properly installed and grounded. Should you only

have a 2-prong outlet, have a qualified electrician

install a correct wall receptacle.

Note:

If you have any questions about the grounding

or electrical instructions, consult a qualified

electrician or service person.

* Can also be installed using an electrical outlet in an

adjacent cabinet within the area where the provided

electrical cord can reach. Always check electrical

codes for requirements.

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event of an

electrical short circuit, grounding reduces the risk of

electric shock by providing an escape wire for the

electric current. This appliance is equipped with a cord

having a grounding wire with a grounding plug. The

plug must be plugged into an outlet that is properly

installed and grounded. Consult a qualified electrician

or serviceman if the grounding instructions are not

completely understood, or if doubt exists as to whether

the appliance is properly grounded.

WARNING

Improper use of the

grounding plug can result in

a risk of electric shock.

Do not use an extension

cord. If the power supply

cord is too short, have

a qualified electrician

or serviceman install an

outlet near the appliance.

DRAWER INSTALLATION

1. Place the drawer adjacent to the wall or cabinet

opening. Plug the power supply cord into the

electrical outlet.

2. Loop (do not tie) a 36” (91 cm) string around the

power supply cord before the drawer is slid into

place. This will keep the cord from falling behind the

drawer.

3. Lift drawer into cabinet cutout using the opening as

a grip. Carefully guide the drawer into the prepared

opening.

4. As you slide the drawer back, pull the string so that

the cord will lie on top of the drawer in a natural loop

and avoid pinching the cord between the drawer and

the wall.

5. When you are sure the cord is out of the way, slide

the drawer ¾ way back into the opening. Remove the

string by pulling on one end of the loop.

6. Slide the drawer all the way until the mounting flange

is flush with the face of the cabinet. See Figure 5.

7. Open the drawer. Using the 4 holes on the mounting

flanges as a template, drill pilot holes the cabinet

using a

1/16

” drill bit. See Figure 5.

8. Secure the drawer with the 4 screws supplied. It is

recommended that the screws be hand tightened.

Preferred electrical

outlet location*

5”

4”

Figure 4

3-prong plug

Grounding pin

3-prong receptacle

Grounded receptacle box

Permanent and

Correct Installation

Mounting

Flange

Figure 5

Parts Supplied

4 Screws