JennAir Stainless Steel Series 25 Inch Countertop Convection Microwave Oven Flush Installation Sheet - Manual (Page 7)

7
IMPORTANT: The flanges of duct 5 go under duct 4. The front
edge of the duct should be flush with the microwave oven itself
and not the door.
Install Rails, Vent Deflectors,
and Bottom Duct
1. Mark vertical line 1 Z\v " (3.2 cm) in on left side of cabinet.
Verify line is level.
2. Make sure notch is at bottom of rail. Position the rail marked
L on the left side of the cabinet with the bottom edge resting
on the cabinet floor. Verify rail is 1 Z\v " back from the face
of the cabinet before proceeding. Drill pilot holes. Attach
mounting rail using 4 #8-14 x Z\x " screws.
NOTE: Drive screws in the center of the holes in the
mounting rail.
Correct Incorrect
1 1 /
4
" (3.2 cm)
Mounting rail
Right rail Left rail
Notches
3. Repeat steps 1 and 2 on right side of cabinet. Use the
following chart and illustration to measure the distance
between center of mounting rail holes. Use shims if
measured distance is incorrect.
27" (68.6 CM)
INSTALLATION
30" (76.2 CM)
INSTALLATION
26 Z\v " (66.7 cm) 29 Z\v " (74.3 cm)
4. Remove protective film from vent deflectors.
5. Position 1 of the vent deflectors in the cabinet, flush with
the top front edge of the opening. Drill pilot holes; then,
fasten deflector with 3 #8-14 x Z\x " screws.
6. Center bottom duct in cabinet so that each side of duct is
the same distance from the side walls and front of duct is
M\, " (2.2 cm) from front of opening.
7. Mark 4 holes on bottom duct for reference.
8. Remove bottom duct from cabinet and drill pilot holes (2 per
side) using marks made in Step 7.
9. Center bottom duct in cabinet, line-up with drilled pilot holes,
and insert 4 #8-14 x Z\x " screws.
Top vent
deflector
7 /
8
"
(2.2 cm)
Pilot Holes Pilot Holes Pilot holes Pilot holes