JennAir Stainless Steel Series 25 Inch Countertop Convection Microwave Oven Flush Installation Sheet - Manual (Page 3)

3
The microwave oven may be located in a cabinet and/or above
a built-in oven or warming drawer. Check the opening where
the microwave oven will be installed. The bottom surface of the
cutout must be a minimum of 36" (91.4 cm) above the floor.
The location must provide:
■
Wood cabinetry.
■
Cutout opening that is plumb and square. See “Minimum
Cutout Dimensions” in the “Minimum Dimensions” section.
■
Cutout floor that is solid, level, and flush with bottom of
cabinet cutout.
■
Support for weight of at least 150 lbs (68 kg) which includes
microwave oven and items placed inside.
■
Grounded electrical outlet. See the “Electrical Requirements”
section.
■
Minimum installation clearances for installation location.
See the “Minimum Dimensions” section.
■
Complete enclosure around the recessed portion
of the microwave oven, including a solid, full ceiling.
■
A level floor – front to back and left to right.
Minimum Dimensions
Minimum Installation Clearances
For proper installation, the following minimum clearances must exist above and below the cutout opening.
Above Cabinet/Storage Drawer Installation Above Oven/Warming Drawer Installation
1"
(25 mm)
1 Z\x "
(38 mm)
1"
(25 mm)
3"
(76 mm)
A
B
C
1"
(25 mm)
1 1 ⁄
2
"
(38 mm)
1"
(25 mm)
3"
(76 mm)
C
B
A
A. Upper cabinet
B. Lower cabinet or storage drawer
C. Lower oven or warming drawer
NOTE: The bottom surface of the cutout must be a minimum of 36" (91.4 cm) above the floor.
Location Requirements