JennAir Rise 27 Inch Built-In Microwave Oven Installation Instructions - Manual (Page 7)

7
2. Push against the front frame of the microwave oven to insert
oven into cabinet. Push microwave oven completely into
cabinet and center in cabinet cutout.
NOTE: Open microwave oven door and push against seal
area of microwave oven front frame when pushing
microwave oven into cabinet. Do not push against outside
edges.
3. Using an 1/8" (3.2 mm) drill bit, predrill pilot holes through
the mounting rails on each side of the microwave oven.
4. Securely fasten microwave oven to cabinet using two 3/4"
(1.9 cm) flat-head screws provided. Insert the screws through
holes in mounting rails. Do not overtighten screws.
5. Replace convection grid, turntable, and support hub.
6. Reconnect power.
7. Display panel will light briefly and the clock should appear in
the display.
8. If display panel does not light, please reference the
“Assistance or Service” section of the Use and Care Guide
or contact the dealer from whom you purchased your
microwave oven.
Complete Installation
1. Check that all parts are now installed. If there is an extra
part, go back through the steps to see which step was
skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. For microwave oven use and cleaning, read the Use and
Care Guide.
Check Operation of Microwave Oven
1. Fill a microwave-safe container with 1 cup (250 mL) of water
and place container on the turntable inside the microwave
oven. Close door firmly.
2. Touch COOK.
3. Set power level, temperature, and cook time to “2:00”
minutes.
4. Press START.
If microwave oven does not operate, check the following:
■
Household fuse is intact and tight or circuit breaker has
not tripped.
■
Electrical supply is connected.
■
See “Troubleshooting” section in the Use and Care
Guide.
When the display reads “1:00” minute, open the microwave
oven door. The microwave oven should stop cooking. Close
door firmly. The interior microwave oven light should turn off.
5. Touch START to resume a preset cycle. The microwave oven
should begin cooking and the microwave oven interior light
should be ON.
Let microwave oven complete cooking time. Tones will
sound at the end of the cooking time and the microwave
oven will shut off.
6. Open microwave oven door and slowly remove container.
Water in container should be hot.
7. To set the clock and other microwave oven functions, refer to
the Use and Care Guide.
If you need Assistance or Service:
Please reference the “Assistance or Service” section of the Use
and Care Guide or contact the dealer from whom you purchased
your built-in microwave oven.
A
B
B
A. Mounting rail
B. Flat-head screws