beautypg.com

Installation instructions, Warning, Prepare built-in oven – JennAir Rise 27 Inch Built-In Microwave Oven Flush Kit Installation Instructions User Manual

Page 4: Install spacer kit, Install microwave oven, Complete installation

background image

4

INSTALLATION INSTRUCTIONS

Prepare Built-In Oven

1.

Attach bottom vent to spacer bars using four 3/8" (9.5 mm)

hexhead washer screws.

NOTE:

Spacer bar flanges should be facing out.

Install Spacer Kit

1.

Center assembled microwave oven spacer kit against lower,

front edge of the cabinet cutout.

2.

Using an 1/8" (3.1 mm) drill bit, drill through the mounting

holes in the spacer bars to create pilot holes.

3.

Attach the assembled spacer kit to the cabinet using four

3/4" (1.9 cm) pan-head screws provided. Do not overtighten

screws.

Install Microwave Oven

Follow the instructions below along with the instructions in the

Electric Built-In Microwave Oven Installation Instructions.
Read the “Electrical Requirements” and “Electrical Connection”

sections, along with all other sections of the Installation

Instructions, before installing the microwave oven.

1.

Using 2 or more people, lift the microwave oven partially into

the cabinet cutout above the spacer kit. Place microwave

oven in between the spacer bar flanges.

NOTE:

When pushing the microwave oven into the cabinet,

open the microwave oven door and push against the seal

area on the front frame. Do not push against the outside

edges.

2.

Push against the front frame of the microwave oven to push

oven into cabinet. Push microwave oven completely into

cabinet and center in cabinet cutout.

Complete Installation

1.

Check that all parts are now installed. If there is an extra

part, go back through the steps to see which step was

skipped.

2.

Check that you have all of your tools.

3.

Dispose of/recycle all packaging materials.

If you need Assistance or Service:

Please reference the “Assistance or Service” section of the Use

and Care Guide or contact the dealer from whom you purchased

your built-in microwave oven spacer kit.

A. Bottom vent
B. Spacer bar flange
C. Spacer bars
D. 3/8" (9.5 mm) hex-head washer screws

A

B

C

D

D

A

B

A. 3/4" (1.9 cm) pan-head screws
B. Spacer kit assembly

A

B

C

C

A. Spacer bar flange
B. Spacer bar
C. Microwave oven

WARNING

Excessive Weight Hazard

Use two or more people to move and install

microwave oven.
Failure to do so can result in back or other injury.

06-May-2019 13:38:40 EDT | RELEASED

In some European factories the letter "W" of the part code mentioned herein will be automatically

replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")