Electrolux Built-In Wall Oven - Manual (Page 30)

30
Electronic Control Settings
USER PREFERENCES
To browse through the User Preferences menu:
1. Press USER PREF to bring up the User Preferences menu.
2. Press USER PREF again to browse through the menu pages.
3. Press
+
hi
or
-
lo
to toggle between the available options.
4. Press START while the chosen option is on display to change.
5. Press CANCEL when finished to get back to the standard oven display.
SETTING THE CLOCK - TIME OF DAY:
The clock may be set for 12 or 24 hour time of day operation (see advanced settings section). The
clock has been preset at the factory for the 12 hour operation. When the range is first plugged in,
or when the power supply to the range has been interrupted, the display will show "CLO 12:00".
The clock must be set before the oven can be used.
When power to the unit has been interrupted, to set the Clock, skip step 1 in the example below
and follow steps 2 and 3.
To set the clock (example for 1:30):
1. Press USER PREF until you get to the CLO 12:00 menu page.
2. Press 1 3 0 pads to set the time of day to 1:30. The pads
+
hi
or
-
lo
can also be pressed
to raise or lower the actual time displayed.
3. Press START to accept the changes and go back to user preferences menu display.
User Preferences menu items:
• CLO 12:00; Setting the clock.
• CLO on; Clock on/off.
• CLO 12hr; 12/24 hour time of day display.
• UPO; Adjusting oven temperature.
The user preferences menu includes all user defined options. This feature enables you to control
the various options of the electronic controls. This menu features the Time of Day, Celsius or
Fahrenheit display mode, Continuous Bake or 12 Hour Energy Saving modes, Clock display or
No-Clock display, 12 Hours Time of Day or 24 Hours Time of Day, Audio Control and Adjusting
the oven temperature. The User Preferences menu is only available when the oven is not being
used (not cooking).
• F-C F; Fahrenheit / Celcius display.
• AUd; Audio on/off and volume.
• E S on; 12 hour Energy Saving on/off.
• rSt ; Reset to default factory settings.