Echo SHC-210 - Manual (Page 9)

H
EDGE
C
LIPPER
O
PERATOR
'
S
M
ANUAL
9
C
ONTENTS
The ECHO product you have purchased has been factory pre-assembled for your convenience. Due to packaging
restrictions, some assembly of SHC-210 is required.
After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing
parts. Use the contents list to check for missing parts.
___ 1 - Power Head/Driveshaft Assembly
___ 1 - Hedge Clipper Assembly
___ 1 - Operator's Manual
___ 1 - Hedge Clipper Safety Manual
___ 1 - Warranty Statement
___ 1 - Warranty Registration Card
___ 1 - Echo Power Blend
TM 2-stroke oil sample
___ 1 - T-Wrench
___ 1 - 4 mm Hex Wrench
___ 1 - Safety Glasses
___ 1 - Blade Cover
A
SSEMBLY
Tools Required: 4 mm hex wrench, screwdriver
Parts Required: Power Head/Drive Shaft Assembly and Gear
Housing Assembly
GEAR HOUSING ASSEMBLY
/
DRIVE SHAFT
WARNING DANGER
Hedge Clipper Blades are very sharp. Wear gloves to protect
hands.
1. Remove protective cap from drive shaft end.
2. Remove locating screw (A) and align the locating hole in the gear
case with the locating hole (B) in the drive shaft housing.
3. Slide the gear housing assembly on the drive shaft. Be certain the
flex drive shaft engages the hole in driver gear and install locating
screw (A).
4. Tighten screw (A) and clamping bolts (C).
IMPORTANT
Flat edge of washers (D) must be against drive shaft.
D
D