Echo SHC-210 - Manual (Page 21)

H
EDGE
C
LIPPER
O
PERATOR
'
S
M
ANUAL
21
Gear Case
Level 2.
Tools required: Grease gun with Lithium Grease, clean rag
Parts required: ECHO
®
LUBE TM 14 oz. cartridge P/N 91015 or
Lithium Based Grease
1. Clean dirt from grease fitting.
2. Carefully pump grease in fitting (A). DO NOT force grease.
Too much pressure will force grease past seals and cause damage.
Apply 1-2 pumps of grease every 15-25 hours of operation.
Drive Shaft Assembly
Level 1.
NOTE
Hedge Clipper drive shaft should be greased every 25 hours of
operation.
Tools required: 4 mm Hex wrench, screwdriver, clean rag, small
brush
Parts required: ECHO
®
LUBE TM 14 oz. cartridge P/N 91015 or
Lithium Based Grease
WARNING DANGER
Blades are very sharp. Wear gloves to protect hands, otherwise
serious personal injury may result.
1. Loosen gear housing assembly locating screw (A) and mounting
screws (C). Remove the gear box from the drive shaft housing.
2. Pull the drive shaft (B) from the housing, wipe clean and re-coat
with a thin coating [1/2 oz. (15 ml)] of grease.
3. Slide the drive shaft back in the drive housing being careful not to
get dirt on the flex shaft.
4. Install the gear housing assembly.
MPORTANT
Flat edge of washers (D) must be against drive shaft.
A
D
D