Epson 30s Series - Manual (Page 5)

4
When you hear two beeps, turn off the MovieMate power switch.
5
Unplug MovieMate.
6
Attach the lens cover when you’re not using MovieMate.
quick
Any problems?
If you don’t find the solution to your problem here, see your
MovieMate 30s Series User’s Guide for more troubleshooting tips.
No picture appears on the screen
 Make sure MovieMate is turned on and warmed up. Turn on the main
power switch on the front and then press the Power button.
 Make sure the lens cover is off.
 The image may be off the screen. Use the up/down and left/right lens
shift dials to adjust its position. See section 5 at the left.
 Make sure MovieMate is not tilted. Tilting it more than 5 degrees up
or down may cause problems. Use the up/down lens shift dial
to adjust the image position.
The picture is blurry or out of focus
 Adjust the focus using the focus ring. See section 5 at the left.
 Make sure the lens cover is off.
 Make sure MovieMate is placed the correct distance from the screen:
no closer than 2.4 feet and no farther than 37 feet.
The picture is taller on the left or right side
Make sure MovieMate is level and facing straight ahead, at a 90-degree
angle to the screen or wall.
The remote control doesn’t work
 Make sure the toggle switch is in the
correct position: set it to -123 to
use the numeric buttons, or to Func.-
to use the other functions of these buttons.
 Check the batteries.
Function/numerics
toggle switch