Electrolux LAVAMAT 50550 - Manual (Page 25)

Instructions for use
25
End of Wash Cycle/Removing the Washing
When a wash cycle is completed, the END (FIN/EINDE) light on the
Programme Progress Display comes on.
If RINSE HOLD (ARRET CUVE PLEINE/SPOELSTOP) was selected, the indi-
cator lights DOOR (PORTE/DEUR) and END (FIN/EINDE) come on.
1. After a Rinse Hold, the water must first be drained:
– Either turn the programme knob to OFF (ARRET/UIT), then to DRAIN
(VIDANGE/POMPEN) and press the START/PAUSE (MARCHE/PAUSE,
START/PAUZE) button (the water is drained without spinning),
or
– turn the programme knob to OFF (ARRET/UIT), then to SPIN
(ESSORAGE/CENTRIFUG.) and press the START/PAUSE (MARCHE/
PAUSE, START/PAUZE) button (the water is drained and the washing is
given a spin; the spin speed can be altered during the spin).
When this stage of the programme is completed, the END (FIN/EINDE)
light comes on.
2. Opening the door.
The door can be opened after the DOOR (PORTE/DEUR) light goes off
and the END (FIN/EINDE) light has come on.
3. Take out the washing.
4. Turn the programme knob to OFF (ARRET/UIT).
5. Close the stopcock.
6. After the wash cycle is completed, pull out the detergent/additives
drawer slightly to allow it to dry. Leave the door slightly open to air the
inside of the washing machine.
Attention! If the washing machine is not used for a long time:
Close the water tap and disconnect the washing machine from the
electricity mains.