Marantz CINEMA 70s 7.2-Channel Network A/V Receiver - Manual (Page 160)

Audyssey ®
Set Audyssey MultEQ ® , Audyssey Dynamic EQ ® and Audyssey Dynamic
Volume ® . These can be selected after Audyssey ® Setup has been
performed.
For additional information on Audyssey technology, please see
“Explanation of terms” ( v p. 266).
0 “MultEQ ® ”, “Dynamic EQ”, “Reference Level Offset” and “Dynamic Volume”
settings are stored for each input source.
0 When the sound mode is in the “Direct” or “Pure Direct” mode, “MultEQ ® ”,
“Dynamic EQ” and “Dynamic Volume” settings cannot be configured.
0
When the sound mode is in “DTS Virtual:X” or sound mode that have “+Virtual:X”
in the sound mode name, “MultEQ
® ”, “Dynamic EQ” and “Dynamic Volume”
settings cannot be configured.
0
This item cannot be selected when a DTS:X format with a sampling frequency of
over 48 kHz is input.
o MultEQ ®
MultEQ ® compensates for both time and frequency characteristics of
the listening area based on “Audyssey ® Setup” measurement results.
Selection is done from three types of compensation curves. We
recommend the “Reference” setting.
Reference
(Default):
Selects the default calibrated setting with
a slight roll off at high frequencies.
Optimal for movies.
L/R Bypass:
Selects the reference setting, but
bypasses MultEQ
® on the front left and
right speakers.
Flat:
Selects the calibrated setting which is
optimized for small rooms where your
listening position is closer to the
speakers.
Off: Do not use “MultEQ ® ”.
0 When using headphones, “MultEQ ® ” is automatically set to “Off”.
Contents Connections Playback Settings Tips Appendix
160
Front panel Display Rear panel Remote Index