Ericsson LBI-39110 - Manual (Page 24)

24
8/SCAN
Scan operation is controlled by this key
sequence (i.e. followed by /SCAN).
Display will read “SCAN ON” or “SCAN OFF”.
(Note: Scan must be off to add/delete groups).
9/SCAN ADD/DELETE
Note: scan must be turned off before editing
the scan list. To edit the scan list, press
followed by . The upper display line will
show “SCAN A/D”. Press again. The
display should change to the current group name.
Press to ramp up to the group to be
changed. Then press to ramp through the
scan options. For a trunked system, these options
are “not in scan” and “in scan”. For a conventional
system, the options are “not in scan”, “in scan” a
“priority 2 channel”, or a “priority 1 channel”. The
scan state replaces the first two letters of the group
name. The complete group name means the
group is “not in scan”. A display line beginning
with “S” means the group is “in scan”. To exit,
press the key.
0/SPC
Entering followed by /SPC
accesses the Special Call List. This list is a
programmable set of call numbers that the user
can invoke by scrolling to the desired call number
in the alpha-numeric display and then depressing
the PTT. Scrolling forward through this list is done
by pressing /GROUP. Scrolling backward
through this list is done by pressing
followed by /GROUP. (See Special PC
programming functions in TQ-3373, for
programming of the Special Call List.) Terminate
Special Call List access by pressing .
Pause
A pause is entered into a stream of DTMF
numbers being dialed via the keypad. The