Ericsson LBI-39110 User Manual

Page 21

Storing A Telephone Number To The Call
List

The number of dial locations (10, 20, 30, 40,

or 50) available is set through radio programming.
The maximum number of digits stored in any
location is 14. The user may dynamically add
phone numbers to the call list by following these
steps:

Enter the phone number, then

followed by

Enter the two digit storage location for

the number (00 to 50).

The new phone number is now added to the

call list at the specified location.

Recalling calls from the call list

Each pre-stored call number has a

corresponding phone number. To dial the phone
number, select the 2 digit call number and press

. Alternately, the user can scroll through the

call list using the

key to scroll forward

through the list.

Simplex Operation

The user can choose to terminate duplex

operation and still maintain the interconnect call in

progress by pressing

followed by

This key sequence toggles between simplex and
duplex operation.

*/System Key usage

The

/System ramp button is used in

multiple contexts. When pressed while in monitor
mode (i.e. radio is not in a special or interconnect
call) the radio ramps through available systems in

one direction. If

followed by

/System is pressed, system ramping takes place
in the opposite direction. If this key is pressed

after any key other than

the

returned.