Peavey IPR2 2000 2-Channel Power Amplifier - Manual (Page 26)

CONNECTING INPUTS
Input connections are made via the 3-pin XLR (pin 2+) or 6.3mm plug combination connectors on the rear panel of the amplifier. The
inputs are actively balanced. The input overload point is high enough to accept the maximum output level of virtually any signal source.
THRU/OUT JACKS
This 1/4” (6.3mm) jack is a parallel connection to the input connector for patching to this amplifier and/or additional power amplifier
inputs. A TRS plug must be used to maintain a balanced connection.
CONNECTING OUTPUTS
All models have one two-pole twist lock and 1/4” (6.3mm) phone plug combination connector per channel. All four speaker connection
wires must be isolated from each other.
CIRCUIT BREAKER
In the unlikely event of operating conditions that may potentially damage the amplifier, the circuit breaker may trip. After inspecting
the cables and connections, the amplifier can be reset. If the circuit breaker trips a second time, contact the local Peavey authorized
service center.
AC POWER INLET:
This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to this connector to provide power to
the unit. Damage to the equipment may result if improper line voltage is used. (See line voltage marking on unit).
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a ground pin, a suitable
grounding adapter should be used and the third wire should be grounded properly. To prevent the risk of shock or fire hazard, always
make sure that the amplifier and all associated equipment is properly grounded.
NOTE: FOR U.K. ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying the terminals
in your plug, proceed as follows: (1) The wire which is colored green and yellow must be connected to the terminal which is marked by
the letter E, or by the Earth symbol, or colored green or green and yellow. (2) The wire which is colored blue must be connected to the
terminal which is marked with the letter N, or the color black. (3) The wire which is colored brown must be connected to the terminal
which is marked with the letter L, or the color red.
Rear Panel
IPR2 ™ 3000 DSP
IPR2 ™ 2000 DSP
11
12
13
14
15
13
14
12 12 10 11 11
10
10
10
11 11
12 12
14
13