Epson V4.10 - Manual (Page 6)

5 Operating environment
Compatible computers
Macintosh computers cannot be used.
* Operations carried out at the computer may become slow depending on the
number of projectors being managed. If this happens, use a computer with
higher specifications.
* EMP Monitor cannot be used in environments which do not allow pings to
be transmitted.
Installing EMP Monitor
If using Windows 2000, NT4.0 or XP, the computer must be started up in
Administrator mode.
PROCEDURE
Turn the computer on, and quit all running
applications.
Place the "EPSON Projector Software for Monitoring"
CD-ROM in the computer's CD-ROM drive.
The installer automatically starts up.
From here, continue with the installation by following
the on-screen messages.
Before starting operations
Check the following points before starting up EMP Monitor.
• EMP Monitor must be installed on the computer to be used for
monitoring and control.
• The computer and the projectors must be connected to the network.
• If using Windows 2000, NT4.0 or XP, the computer must be started up in
Administrator mode.
When using EMP-6000/821/81/61
• A commercially-available serial
⇔ TCP/IP conversion adapter and a
connection cable are required in order to use EMP Monitor.
s"Standby mode" in the projector's User's Guide
• Make the settings for the serial ⇔ TCP/IP conversion adapter before
connecting to the projector.
OS 98SE/Me/NT4.0/2000 Professional/XP Home Edition/XP
Professional
• Internet Explorer Ver. 5.0 or later must be installed.
CPU Pentium MMX 166 MHz or higher (Pentium II 233 MHz
or higher recommended)
Memory
capacity 64 MB or more (128 MB or more recommended)
Free hard disk
space 50 MB or more
Display SVGA (800 × 600) or higher resolution, 32 bit or higher
display colour
1
2
3