Epson V4.10 User Manual
Page 31
30
If a problem notification e-mail message has been sent
If a problem occurs with a projector, an e-mail message containing the
following will be sent to all e-mail addresses that have been specified in
"Recipient mail address".
If there is more than one problem or warning, each message will appear on
separate lines.
The details contained in the e-mail message can consist of the following.
Messages to inform that the projector has recovered from the error or
warning statuses are sent.
Item
Details shown
E-mail subject
[Display name displayed in "Grouping view" or
"Detail list view"] Projector warning/error
notification
Body
The following warning/error occurred on
Immediately check the projector.
Message
Remedy
Internal (system) error
"Reading the indicators"
s"Reading the Indicators" in the projector's
User's Guide
Fan error
Sensor error
Open lamp cover door
error (lamp error)
Lamp failure at power on
Lamp out
High internal
temperature error
High-temperature
warning
Lamp life warning
"Reading the indicators"
s"Reading the Indicators" in the projector's
User's Guide
Replace Air Filter
No Air Filter
Low Air Flow
Air Flow Sensor Err.
No signal
No image signals are being received by the
projector. Check the connection status and
check that the power for the connected
equipment is turned on.
Other error
Stop using the projector, disconnect the
power cable from the electrical outlet, and
contact your local dealer or the nearest
address provided in the World-Wide Warranty
Terms supplied with the projector.
Network error (TCP
connection error)
Check that the projector's power is turned on
and the LAN cable is connected, and also
check that "Network Monitoring" is set to
"ON" and "Standby Mode" is set to "Network
ON".
Network error (ESC/
VP.net communication
error)
Check that the projector has been correctly
connected to the network.
Network error (monitor
password authentication
error)
Check the projector's Monitor Password.
Message
Remedy