beautypg.com

Electrolux HD 8960 User Manual

Page 8

background image

8

If the hood is off when the Intensive speed is activated, the hood will

automatically turn off after 5 minutes.

To interrupt the Intensive speed, press button 1 or 5.

The letter P appears on the display and the remaining time (the point “a” is

flashing), if interrupted an acoustic signal is heard.

7 - Self-Timer: times all the speed levels (the point “b” is flashing), and then the

cooker hood switches off:

The self-timer is set as follows:

1

st

speed level 20 minutes

2

nd

speed level 15 minutes

3

rd

speed level 10 minutes

P (intensive) speed level: 5 minutes

The display shows the remaining operation time, at the end of the time an

acoustic signal is heard. Depressing the push-button again exits the function.

Automatic Sensor calibration:

The automatic calibration is carried on by the hood itself every 30 minutes.

When the hood is installed for the first time or the power is cut off for many hours

or days, please wait 30 minutes before the use or make a manual calibration.

Manual Sensor calibration

Carry out calibration with the hob off, at normal ambient room temperature and in

the absence of an appreciable amount of steam:

-press switch 3 for about 3secs , then press switch 1, the hood emits a sound

signal to indicate calibration taking place.

Sensors test

When functioning in Automatic mode, the system continuously tests the efficiency

of the sensors. In case of a fault the display shows “88”. Contact your local

Service Force Centre..

In this situation the hood can, in any case, be used in the manual mode.

Safety procedure

Self-activation of Automatic (SAFETY) mode:

if the sensors reveal an excessive increase in temperature, even if the hood is

in Manual mode, the system self selects the Automatic mode and the hood

selects the necessary speed. The hood can be turned off by pressing push switch

1.

Should the hood or the controls fail to operate: disconnect the power supply for at

least 5 seconds.

After reconnecting the power supply wait 15 seconds and then check that the cooker

hood is now operating correctly.