Motorola Defy Satellite Link - Manual (Page 12)

motorola defy satellite link
12
FCC Regulation
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference re-
ceived, including interference that may cause undesired operation.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit diff erent from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC note:
Caution: Changes or modifi cations not expressly approved by the party responsible for compliance could void the
user‘s authority to operate the equipment.
RF Exposure information (SAR)
This device is designed and manufactured not to exceed the emission limits for exposure to radio fre-
quency (RF) energy set by the Federal Communications Commission of the United States.
During SAR testing, this device was set to transmit at its highest certifi ed power level in all tested fre-
quency bands, and placed in positions that simulate RF exposure near the body with the separation of
5 mm. Although the SAR is determined at the highest certifi ed power level, the actual SAR level of the
device while operating can be well below the maximum value. This is because the device is designed to
operate at multiple power levels so as to use only the power required to reach the network.
The exposure standard for wireless devices employing a unit of measurement is known as the Specifi c
Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6 W/kg.
This device is complied with SAR for general population/uncontrolled exposure limits in ANSI/IEEE C95.1-
1992 and had been tested in accordance with the measurement methods and procedures specifi ed in
IEEE1528. The FCC has granted an Equipment Authorization for this device with all reported SAR levels
evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this device is on
fi le with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid after
searching on FCC ID: ZL5BM3A01.
The highest reported SAR values under the FCC regulatory for the device are listed below:
Body SAR: 1.42 W/kg
While there may be diff erences between the SAR levels of various device and at various positions, they
all meet the government requirements.
SAR compliance for body-worn operation is based on a separation distance of 5 mm between the unit