Electrolux 5540 - Manual (Page 18)

18
Cleaning heat exchanger
If the
y HEAT EXCHANGER display is illuminated, the heat exchanger
needs to be cleaned.
1
Caution! Operating when the heat exchanger is clogged with lint can
damage the dryer. This also increases energy consumption.
1. Open loading door
2. Open base door. To do this, press
the release button on the bottom
of the loading opening and open
the door to the left.
3. Remove lint from the inside of the
door and the heat exchange cham-
ber.
4. Turn both lock washers inwards.
5. Pull heat exchanger out of base by
the handle.
1
Caution! Do not use sharp objects
to clean. The heat exchanger could
develop leaks.
6. Clean heat exchanger.
It is best to use a brush or to rinse
thoroughly with a shower head.
7. Replace heat exchanger and lock
into place (turn both lock washers outwards until they snap into place).
8. Close base door.
3
The dryer will not operate if the base door is not closed.
1
Caution! Never operate the dryer without the heat exchanger.