Electrolux 318 203 603 (0709) - Manual (Page 25)

25
CARE & CLEANING TABLE
General Care & Cleaning
Surfaces
Aluminum & Vinyl
Painted and Plastic
Control Knobs
Stainless Steel, Chrome
Control Panel, Decorative
Trim
How to Clean
Use hot, soapy water and a cloth. Dry with a clean cloth.
Using a soft cloth, clean with mild dish detergent and water or a 50/50 solution
of vinegar and water. Follow by rinsing the area with clean water; dry and polish
with a soft cloth. Glass cleaners may be used if sprayed on a soft cloth first. DO
NOT spray liquids directly on the control pad and display area. Do not use large
amounts of water on the control panel - excess water on the control area may
cause damage to the appliance. Do not use other liquid cleaners, abrasive
cleaners, scouring pads, or some paper towels - they will damage the finish. To
remove control knobs, turn to the OFF position; grasp firmly and pull straight off
the shaft. To replace knobs after cleaning, line up the flat sides of both the knob
and the shaft; then push the knob into place.
Clean stainless steel with hot, soapy water and a dishcloth. Rinse with clean water
and a cloth. Do not use cleaners with high concentrations of chlorides or
chlorines. Do not use harsh scrubbing cleaners. Only use kitchen cleaners that are
especially made for cleaning stainless steel. Always be sure to rinse the cleaners
from the surface as bluish stains may occur during heating that cannot be removed.