Electrolux 318 203 603 (0709) - Manual (Page 18)

18
Setting Surface Controls
USING THE TOUCH CONTROL
Fig. 1
OPERATING THE SINGLE SURFACE RADIANT ELEMENT
!
CA CA CA CA CAUTION UTION UTION UTION UTION
Radiant surface elements may appear to have cooled after they have been turned OFF. The Hot Element (HE) message will be
showed and will continue to display until the glass cooktop has cooled down to a moderate level. The glass surface may still
be hot and burns may occur if the glass surface is touched before the display has turned OFF.
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top of the range when it is in
use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the surface elements.
The cooktop has a single radiant surface element at the position shown on Figs. 2 & 3.
To Operate the Single Surface Element
1. Place correctly sized cookware on the radiant surface element.
2. Touch and hold the
POWER
key pad until a beep sounds. The power indicator light
above the
POWER
will turn ON. Note: If no other key pad is touched within 20
seconds the request to Power ON the cooktop will clear.
3. Touch and hold the
ON OFF
pad for the desired element position until a beep is
heard. The display will show "0.0". Note: If no further pads are touched within
10 seconds the request to power the element ON will clear.
4. Touch pad once to turn ON the power level to HI or touch pad
once for power level to Lo.
5. Each touch of the or pad will increase or decrease the power
level. Lo is the lowest power level available. Note: The power level may
be adjusted at any time while the element is ON.
6. When cooking has been completed touch the
ON OFF
pad once to turn the
lo - hi + lo - hi + lock warm hi + lo - hi + lo - timer POWER ON OFF
lock warm lo - hi + lo - hi + lo - hi + hi + lo - hi + lo - timer POWER ON OFF ON OFF ON OFF ON OFF ON OFF
Fig. 2
Fig. 3 element OFF and if no other surface element is used touch the
POWER
key pad to turn off
the cooktop. Each surface element provides a constant amount of heat at each
setting. A glowing red surface heating area extending beyond the bottom edge of the
cookware indicates the cookware is too small for the surface heating area. Note: The
Hot Element (HE) message will be showed on display for each element until the
heating surface area has cooled sufficiently.
The recommended way to use the touch pads on the cooktop is shown in Fig. 1. Be
sure that your finger is placed in the center of the touch pad as shown. If the finger is
not placed on the center of a pad, the cooktop may not respond to the selection
made.
Lightly contact the pad with the flat part of your entire fingertip. Do not just use the
narrow end of your fingertip.