Echo PPT-265S - Manual (Page 23)

P
ower
P
runer
TM
o
PeraTor
'
s
M
anual
23
spark pluG
Level 2.
Tools required: 10x19mm (13/32x3/4in) T-wrench, Feeler gauge,
Soft metal brush
Parts Required: Spark Plug NGK BPM-8Y
IMPORTANT
Use only NGK BPM-8Y spark plug (BPMR-8Y in Canada) oth-
erwise severe engine damage may occur.
1. Remove spark plug and check for fouling, worn and rounded center
electrode.
2. Clean the plug or replace with a new one. DO NOT sand blast to
clean. Remaining sand will damage engine.
3. Adjust spark plug gap 0.65mm (0.026 in.) by bending outer elec-
trode.
4. Tighten spark plug to 150-170 kgf • cm (130-150 in • lbf).
coolInG system cleanInG
Level 2.
Tools required: 4 mm Hex wrench, Cleaning brush 25 - 50 mm
(1 - 2 in.)
Parts Required: None.
IMPORTANT
To maintain proper engine operating temperatures, cooling air must
pass freely through the cylinder fin area. This flow of air carries
combustion heat away from the engine.
Overheating and engine seizure can occur when:
• Air intakes are blocked, preventing cooling air from reaching the
cylinder.
• Dust and grass build up on the outside of the cylinder. This build up
insulates the engine and prevents the heat from leaving.
Removal of cooling passage blockages or cleaning of cooling fins is
considered “Normal Maintenance.” Any failure attributed to lack of
maintenance is not warranted.
0.65 mm
(0.026 in.)