beautypg.com

Saw chain tension adjustment – Echo PPT-265S User Manual

Page 14

background image

14

saW

chaIn

tensIon

adJustment

WARNING

Always disconnect spark plug wire before servicing cutting attach-

ment. Wear gloves when handling saw chain, otherwise serious

personal injury may result.

To Adjust Saw Chain Tension

1. Move stop switch to STOP position.

2. Disconnect spark plug lead.

3. Loosen two gearcase cover nuts (A) until finger tight.

4. Hold the bar nose up, and turn the adjuster screw (B) clockwise un-

til the chain fits snugly against the underside of the bar, as shown.

Cold Chain Only - turn adjuster screw CW an additional 1/8 - 1/4

turn.

5. Tighten both gearcase cover nuts with nose held up. Tighten rear

nut first.

6. Pull the chain around the guide bar by hand. Reduce the chain ten-

sion if you feel tight spots.

7. When chain is properly tensioned, tighten gear case cover nuts

securely.

IMPORTANT

Tighten gearcase cover nuts to 8 - 9 N•m (71 - 80 in. lbs.) DO

NOT over-tighten nuts. Damage may result.

8. Keep chain properly tensioned at all times.

NOTE

All chains require frequent adjustment.

9. Connect spark plug lead.

A

B