Echo PB-250 - Manual (Page 16)

16
aIr fIlTer
Level 1.
Parts required: REPOWER TM Air and Filter Kit
NOTE
Clean daily.
1. Close choke (Cold Start Position [ ]). This prevents dirt from
entering the carburetor throat when the air filter is removed. Brush
accumulated dirt from air cleaner area.
2. Remove air filter cover. Brush dirt from inside cover.
3. Remove air filter and lightly brush debris from filter. Replace
filter if it is damaged, fuel soaked, very dirty, or the rubber sealing
edges are deformed.
4. If filter can be reused, be certain it:
• Fits tightly in the air filter cavity.
• Is installed with the original side out.
5. Install air filter cover.
fuel fIlTer
Level 1.
Parts required: REPOWER TM Air and Filter Kit
DangEr
Fuel is VERy flammable. Use extreme care when mixing, storing
or handling.
1. Use a clean rag to remove loose dirt from around fuel cap and
empty fuel tank.
2. Use the “fuel line hook” to pull the fuel line and filter from the
tank.
3. Remove the filter from the line and install the new filter.
NOTE
Federal EPA regulations require all model year 2012 and later
gasoline powered engines produced for sale in the United States to
be equipped with a special low permeation fuel supply hose between
the carburetor and fuel tank. When servicing model year 2012 and
later equipment, only fuel supply hoses certified by EPA can be used
to replace the original equipment supply hose. Fines up to $37,500
may be enforced for using an un-certified replacement part.)