Epson 2000/XP - Manual (Page 3)

INSTALLING
IMAGEPRINT
IMPORTANT: DO NOT INSERT THE USB DONGLE
UNTIL INSTRUCTED TO DO SO. THE SOFTWARE
WILL NOT INSTALL PROPERLY IF THE STEPS ARE
NOT FOLLOWED IN THE ORDER PRESENTED .
Before installing
IMAGEPRINT,
verify that the printer is
operating properly and that there is proper communication with
the computer.
LOCATE THE PROPER PORT NAME
Skip this step if installing a Fuji Pictrography or a printer
connected via ethernet.
Go to the Windows Start Menu and locate the Printers folder in
the control panel.
Right Click on the printer that you are going to use with
IMAGEPRINT .
Choose Properties and Click on the Port tab. The Window
should look similar to the one shown below.
Locate the box with a
check mark in it. In this
example, the Windows
operating system has
assigned the port
“USB002” to our Epson
1280. Your printer port
may be dirfferent. Be
sure to write down the
port name for your
printer in the space
below then Click Cancel.
Record your Port Name
for later use.
In this example the printer is an Epson 1280.
Confirm that your printer name appears here.