Eaton Electrical Powerware 3105 UPS - Manual (Page 7)

UserÊs Manual 350-700VA Rev B 7
Indicators
1. On/Off Push Button/Test Switch
One switch controls the power to your equipment. Upon power turn on, unit
performs a self-test to detect overload or undercharged conditions.
Turn on the UPS
Press and hold the push button switch depressed for more than one second.
Release the switch after the audible beep is sounded.
Turn off the UPS
Press and hold the push button switch for more than one second and release the
switch after the audible beep is sounded. The UPS will shut down.
Self-Test
The UPS performs a self-test for about 3 seconds when the UPS is turned on.
2. On/Off Battery LED
Indicates the UPS is on and is powering your equipment.
A constantly illuminated LED indicates normal utility power operation.
A blinking LED indicates that the UPS is providing power from its battery.
3. Fault/Warning LED
Indicates a fault or warning condition is present.
A constantly illuminated LED indicates a LOW battery condition.
A blinking LED indicates the UPS is overloaded.
4. Battery Backup & Surge Protection Outlets
(3) Australian 10 Amp output receptacles that provide both battery backup and surge
protection.
5. Surge Protection Outlets
3) Australian 10 Amp output receptacles that provide surge and spike protection.
2 1 3 4
5