Electrolux EWN 13570 W - Manual (Page 14)

14 electrolux use
Alarm codes
If there is a fault, some alarm codes can
be displayed, for example
E20 (see
paragraph “Something not working”).
End of programme
When the programme has finished a
flashing zero is displayed, the “Door”
pilot light and the Start/Pause light
go out and the door can be opened.
Heating phase
During the washing cycle the display
shows the temperature icon animated
to indicate that the appliance has
started the heating phase of the water
in the tub.
2.05
0.00
E20
Select the Start/Pause
To start the selected programme, press
the Start/Pause button; the green pilot
light stops flashing.
The «Door» pilot light illuminates to
indicate that the appliance starts
operating and the door is locked.
The «Door» pilot light indicates if
the door can be opened:
• light on: the door cannot be opened.
The appliance is running.
• light off: the door can be opened.
The washing programme is finished.
To interrupt a programme which is
running, depress the Start/Pause
button: the green pilot light starts to
flash.
To restart the programme from the point
at which it was interrupted, press the
Start/Pause button again.
If you have chosen a delayed start, the
machine will begin the countdown.
If an incorrect option is selected, an
integrated red pilot light of the Start/
Pause button flashes for 3 times and
the message Err is displayed for about
2 seconds.
Start/
Pause
132972120 EN.qxd 26/10/2007 11.28 Pagina 14