Electrolux HE 3160 - Manual (Page 18)

18
• Fix the base spacer M to the wall with the two screws R 5x45
provided using either the long or the short arm, depending on the
depht of the side cupboards. Do not tighten the screws fully. Fig. 11.
• Fix the hood to the wall by means of the two hooks P
previously mounted, but first move the upper brackets S so
that the front panel of the hood, once mounted, will be in line
with the front edge of the cupboard doors. The two upper
brackets S, located at the top rear edge of the hood may be
slid backwards and forwards by loosening its fixing screws T
adjacent to them on the upper hood surface. Fig. 11.
• Check that the hood is at the right height. Minor height adjustments
may be made with the screws U embodied in the brackets. Fig. 11.
• Tighten the two wall fixing screws R, through the two access holes
N provided on the inside of the hood then fix the lower sliding frame
to the hood with two screws O and washers. Fig. 11.
Fixing a furniture door to the visor
Before fixing the furniture door to the visor, please ensure the distance
distance between the plate and the upper edge of the cabinet door is
correct (depends on the thickness of the material and whether or not
there is an upper shelf). Fig. 6.
• Remove the grease filters. Fig. 3.
• Take off the visor G by turning the rear locking knobs H. Fig. 13.
b
a a b
0 = 17
16 = 33
19= 36
Fig. 12