Philips X-Line 55BDL4007X 55" Full HD Video Wall Display - Manual (Page 12)

55BDL4005X/55BDL4007X
1
1. Unpacking and Installation
1.1. Unpacking
• This product is packed in a carton, together with the standard accessories.
• Any other optional accessories will be packed separately.
• As this product is high and heavy, the operation of moving the device is recommended to be performed by two technicians.
• After opening the carton, ensure that the contents are complete and in good condition.
1.2. Package Contents
Please verify that you received the following items with your package content:
• LCD display
• Remote control with AAA
batteries
• Power cord
• DVI cable
• HDMI cable
• RS232 cable
• RS232 Daisy chain cable
• IR sensor cable
• IR cable
• Quick start guide
• Edge Alignment Kit-1: 1PCS
• Edge Alignment Kit-2: 2PCS
• Edge Alignment Pin: 2PCS
• AC Switch Cover
• Wire Clamper: 3 PCS
• Gap Mylar: 3 PCS
* The supplied power cord varies depending on destination.
Quick start guide
Remote Control
and AAA Batteries LCD Display
Power Cord
RS232 Cable
RS232 Daisy Chain Cable Edge Alignment Kit-1
Edge Alignment Kit-2
IR Sensor Cable IR Cable
DVI Cable Edge Alignment Pin
AC Switch Cover
HDMI Cable
Wire Clamper
Gap Mylar
* Differences according to regions.
Display design and accessories may differ from those illustrated above.
NOTES:
• For all other regions, apply a power cord that conforms to the AC voltage of the power socket and has been approved by and
complies with the safety regulations of the particular country.
• You might like to save the package box and packing material for shipping the display.
1.3. Installation Notes
• Only use the power cable provided with this product. If an extension cord is required, please consult your service agent.
• The product should be installed on a flat surface, or the product may tip over. Leave a space between the rear of the product
and the wall for proper ventilation. Do not install the product in a kitchen, bathroom or a place exposed to moisture, failure
to do so may shorten the life of the internal parts.
• Do not install the product where it is 3000m and higher in altitude. Failure to do so may result in malfunctions.