Glide Gear POV100 Helmet (L / XL) - Manual

POV 100
1
PLEASE NOTE:
 For use with cameras weighing up to 2.5lbs or
1.15kg including the lens
 The POV100 comes in 2 sizes: M (54-60cm/21.25-
23.6”) and L (56-62cm/22-24.4”)
 Recommended use with wide angle lenses set to
infinity focus for best results
For more information please visit our website: www.glidegear.net
2
Fig A
4
Mount your camera using the screw
inside the slot in the crossbar in the
front of the helmet. See Fig A.
Crossbar
Mounting
screw
3
Included with the POV 100 are 10 weight plates. With
the camera mounted in the front, your head will be
leaning forward. Add weight plates to the back of the
helmet to balance your head and ease the strain on
your neck. Use the supplied thumb nut to secure the
weight plates in an unloose position. See Fig. B
Fig C
Hint: Weigh your camera and use the appropriate
number of plates to get as close as possible to the
camera weight knowing that 1 plate weighs about
4oz (or 100g).
Example: For a camera weighing 1.6lbs, add 6-7
plates to the back.
Thumb nut
In the rear inside of the helmet, you will find a knob.
Use the knob to tighten or loosen the helmet’s inside
frame so that the helmet fits tightly on your head.
The knob in question is circled on Fig. C.
Fig B