Electrolux 1610 - Manual (Page 36)

36
Making the appliance level
3
Automatic adjusting foot: The rear foot on the left-hand side of your
washing machine is built as a shock absorbing foot. This guarantees
that the appliance does not move even at high spin speeds.
The four feet of the appliance are
pre-adjusted.
Large degrees of unevenness can be
compensated for by adjusting the
four feet of the appliance.
Use the special spanner supplied to
do this.
Important: Do not use pieces of
wood, cardboard or such like to lev-
el out small degrees of unevenness
in the floor. Adjust the adjustable
feet instead.
Electrical Connection
Any electrical work required to install this appliance should be carried
out by a qualified electrician or competent person.
1
WARNING – THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should these safety measures
not be observed.
Before switching on, make sure the electricity supply voltage is the
same as that indicated on the appliance rating plate.
The appliance is supplied with a 13 amp plug fitted. In the event of
having to change the fuse in the plug supplied, a 13 amp ASTA ap-
proved (BS 1362) fuse must be used.