Electrolux 1610 - Manual (Page 28)

28
The washing machine
vibrates when operat-
ing or is not stable.
The transit packaging has not
been removed. Removing the transit pack-
aging.
The screw feet not correctly
adjusted.
Adjust the feet as described
in the installation and con-
nection instructions.
There is very little washing in
the drum (e.g. only one
bathrobe).
This does not affect how the
machine operates.
Water is leaking out
from under the
washing machine.
The screw connection on the
inlet hose is leaking. Screw the inlet hose in
firmly.
The drainage hose is leaking. Replace drain hose.
The drain pump cover is not
closed properly.
Close the cover properly.
Washing was caught in the
door. Load washing carefully for
the next wash.
Emergency drain hose is
leaking. Close off emergency drain
hose properly.
Softener was not
washed in.
compart-
ment for conditioners
is filled with water.
The conditioner insert is not
correctly set into the addi-
tive compartment or is
blocked.
Clean the detergent dispens-
er drawer, insert the condi-
tioner insert firmly.
Washing is heavily
creased.
There may have been too
much washing in the ma-
chine.
Observe maximum loads.
The door cannot be
opened when the ap-
pliance is switched on.
The
symbol appears
in the display.
The door is locked for safety
reasons. Wait until the
symbol ap-
pears.
The display goes out
while a wash cycle is
running.
Power cut.
For safety reasons, the door
will remain locked for ap-
prox. 4 minutes.
The programme will continue
when the power cut is over.
To remove washing:
If water can be seen in the
appliance, before opening
the door, first perform an
emergency drain.
The background illumi-
nation of the display
has gone out even
though the appliance is
switched on.
The washing machine is in
stand-by mode.
Press any key.
Problem Possible cause Remedy