Creality K1 Max 3D Printer - Manual (Page 9)

● Caution:
● Do not power up the machine while you are connecting or
disconnecting the touch screen.
The flexible flat cable of the base is pulled lightly and
broken carefully.
● Please ensure the correct position for the power supply switch and mains before
supply connection, in order to avoid damage to the device.
● If the mains between 100V and 120V, please select the 115V for the power supply switch
with a straight screwdriver.
● If the mains between 200V and 240V, please select the 230V for the power supply switch
(default is 230V) with a straight screwdriver.
Caution:
01 06
2.2 Install the Product
① Take the touch screen out of the tool box and connect the touch screen to the flat cable extended from the base according to Figure A.
Then snap the touch screen into the slot in the baseplate, as shown in Figure B. (The direction is as shown in the figure; otherwise, the screen interface may be damaged.)
B
A
1
15V 230V
③ Load filaments.
(Insert the filaments into the deepest part of
Teflon tube until it cannot be moved.)
④ Install the top cover. ② A: Connection and power on.
B: Install the material barrel.
A
B
Push
down
2. Unboxing