Profoto A10 AirTTL-C Studio Light for Canon - Manual (Page 33)

A
10 Air
TTL
33
www.profoto.com
requested flash energy is out-of-range while using TTL. Factory default
setting is OFF.
Display Brightness
The backlight of the display [9] has an impact on the battery time.
There are three backlight options:
• MIN
• MEDIUM
• MAX
Standby
There are three standby options:
• 2 MIN: Standby mode is entered after 2 minutes of inactivity.
• 30 MIN: Standby mode is entered after 30 minutes of inactivity.
• OFF: Standby mode is disabled. This setting also disables the
auto power off function.
If the Standby timer is active, there is a corresponding Auto Power Off
timer set to 90 minutes.
Regulatory info
Displays important regulatory information for various markets. See also
markings on the A10 unit and chapter Regulatory information.
About
Displays hardware variant and current firmware installed on A10. Reset
button will set A10 to factory default settings.
AF assist
The AF (autofocus) assist setting activates or deactivates the AF assist.
The AF assist light works with a structured laser light ‘which is generally
harmless for the eye, although the hazard increases if viewed with
optical aids, including magnifiers, binoculars, or telescopes.
• OFF: Deactivates the AF assist
• AUTO: The camera activates the AF assist automatically when
needed if the A10 is connected to a compatible camera
• ON: Activates the AF assist so that it is always on.