Eclipse - Fujitsu Ten CD7200 MKII - Manual (Page 86)

86
Various Settings
ATTENTION
The clock display can also be turned on and off
by pressing the button [6] while the power is
turned off.
Setting time (Clock Adjust)
This main unit uses the 12-hour display notation.
The clock setting mode is activated.
Right:
Minutes will be switched.
Left:
Hours will be switched.
Up:
Turns the time forward.
Down:
Turns the time back.
Switching demonstration screen
display (Demo)
Demonstration screen display settings can be
performed. Default setting is ON.
If the demonstration screen display is set to ON,
operation, motion picture, and other screens will
be displayed in succession.
If you press a button while the demonstration
screens are being displayed, the demonstration
screens will be cancelled and the audio operation
screen will be displayed. If you do not operate
the status display function within 15 seconds, the
display will return automatically to the demo
screen.
The demo display setting mode is
activated.
Setting spectrum analyzer
sensitivity (S/A Sensitivity)
The sensitivity of the spectrum analyzer display
can be changed.
The spectrum analyzer sensitivity
setting mode is activated.
When the button is pressed, the
spectrum analyzer sensitivity changes
in the following order.
Hi ↔ Mid ↔ Low ↔ Hi ↔ www
1
Press the [SELECT] (Up/Down)
button to select Clock Adjust.
2 Press the [ENTER] button.
3
Press the [SELECT] (Right/Left)
button to select the item to be
adjusted.
4
Press the [SELECT] (Up/Down)
button to adjust the time.
5 Press the [ENTER] button.
1
Press the [SELECT] (Up/Down)
button to select Demo.
2 Press the [ENTER] button.
3
Press the [SELECT] (Up/Down)
button to select Demo ON/OFF.
1
Press the [SELECT] (Up/Down)
button to select S/A Sensitivity.
2 Press the [ENTER] button.
3
Press the [SELECT] (Up/Down)
button to select the spectrum
analyzer sensitivity.