Nikon 20x120 IV Telescopic Binoculars with Fork Mount - Manual (Page 11)

11
Jp
En
Installation procedures for the binocular telescope
Attaching the fork mount to a base
1. Make six 12 mm (1/2 in.) screw holes or
through holes in a base.
• Make the holes so that they match the
attachment holes at the bottom of the
fork mount ( A ).
2. Attach the fork mount to the base.
• Use 12 mm (1/2 in.) bolts, or bolts and
nuts, to firmly fasten the fork mount and
base.
Dimensional drawing of the bottom of the fork mount
148 mm
180 mm
6- ໅ 13.5 mm
A
Attaching the binocular telescope to the fork mount
* Make sure not to drop the binocular telescope because it is heavy.
1. Loosen the two body fixing screws on the fork mount and open the left and right shaft holder lids.
• The correct attachment orientation of the fork mount is when the Nikon logo is in front of you.
2. Place the body on the fork mount.
• Insert the pin on the right side of the
body into the pin hole on the right side
of the fork mount ( B ).
B
Pin hole
Pin
3. Close the left and right shaft holder lids
( C ), and firmly tighten the body fixing
screws.
C