PreSonus Eris HD10BT Studio Headphones with Active Noise Canceling and Bluetooth 5.0 - Manual (Page 5)

3
2. Hookup
2.1. Right Earpiece Connections and Controls
Eris HD10BT
Owner’s Manual
2. Hookup
2.1. Right Earpiece Connections and Controls
2.1.1. Bluetooth Pairing and Powering
To power on your Eris HD10BT headphones, press and hold the center button for 3
seconds, if no Bluetooth device is paired or the previously paired Bluetooth device is
not available, your Eris HD10BT headphones will enter pairing mode.
While in pairing mode, the LED on the lower right of the earpiece will flash blue and red.
On your Bluetooth device, select “PreSonus HD10BT” from the pairing menu.
To power down your Eris HD10BT headphones, press and hold the center button for
5 seconds.
2.1.2. Track Navigation and Bluetooth volume
The following controls are available for use with your
favorite Bluetooth device while listening to audio:
1
2
3
1. Volume Up / Prev Track. Press once to increase the Bluetooth
playback volume. Press and hold to navigate to the previous track.
2. Play/Pause. Press this button to remotely start and
stop playback on your Bluetooth device.
3. Volume Down / Next Track. Press once to lower the Bluetooth
playback volume. Press and hold to advance to the next track.
Hold for 3 sec
Bluetooth < Settings
Bluetooth
PreSonus HD10BT
My Devices
Other Devices
Now discoverable as “My Phone”
Hold for 5 sec