Companion presonus products – PreSonus Eris HD10BT Studio Headphones with Active Noise Canceling and Bluetooth 5.0 User Manual

Page 4

1 Overview

1.3.

Companion PreSonus Products

Eris HD10BT

Owner’s Manual

Hardshell carrying case

PreSonus Health, Safety, and Compliance Guide for Headphones

1.3.

Companion PreSonus Products

Thanks for choosing PreSonus! As a solutions company, we believe the best way to
take care of our customers (that’s you) is to ensure that you have the best possible
experience from the beginning of your signal chain to the end. To achieve this goal,
we’ve prioritized seamless integration throughout every design phase of these
products from day one. The result is systems that communicate with each other
as intended – straight from the box – without excessive configuration hassles.
We’re here for you. Find out more at www.presonus.com

PreSonus Safety Warnings and Instructions

Electrical information and warning symbols for PreSonus products are located on the rear electrical panel of the unit

adjacent to the electrical plug or on the bottom of the unit along with other product compliance information.

This lightning flash

with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of non-

insulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock.

WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) AS THERE

ARE NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.

The exclamation point

within an equilateral triangle is intended to alert the user to the presence of

important operating and maintenance instructions in the literature accompanying the appliance.

CAUTION:

To reduce the risk of electric shock, do not expose this appliance to rain and moisture. Do not expose this device

to dripping or splashing liquids and no object filled with liquids, such as vases, should be placed on the device.

CAUTION:

These service instructions are for use by qualified service personnel only. To reduce the risk of electric shock,

do not perform any servicing other than that contained in the operation instructions. Qualified service personnel must

perform repairs.

Read these instructions.

Keep these instructions.

Heed all warnings.

Follow all instructions.

Do not use this device near water.

Clean only with a dry cloth.

Do not install near any heat sources, such as radiators, heat registers, stoves,

or other device (including amplifiers) that produce heat.

Protect the power cord from being walked on or pinched, particularly at plugs,

convenience receptacles, and the point where they exit from the device.

Use only attachments/accessories specified by PreSonus.

10. Unplug this device during lightning storms or when unused for long periods.
11. Servicing is required when the device has been damaged in any way, such as if a power-supply cord or plug is

damaged; or liquid is spilled, or objects have fallen into the device; or if the device has been exposed to rain

or moisture, does not operate normally, or has been dropped. All PreSonus products in the USA should be

serviced at the PreSonus factory in Baton Rouge, Louisiana. If your PreSonus product requires a repair, contact

[email protected] to arrange for a return authorization number. Customers outside the USA should

contact their local distributor. Your distributor’s contact information is available at www.presonus.com.

12. Protective grounding(earthing) terminal. The apparatus should be connected to a

mains socket outlet with a protective grounding(earthing) connection.

13. Where the Mains plug or an appliance coupler is used as the disconnect device,

the disconnect device shall remain readily operable.

14. The use of apparatus is in moderate climates.
15. Please allow 5cm around the apparatus for sufficient ventilation; the ventilation should not be impeded

by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc.

SPL Warning:

Exposure to extremely high noise levels may cause permanent hearing loss. Individuals vary considerably in susceptibility to

noise-induced hearing loss but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a period of

time. The U.S. Government’s Occupational Safety and Health Administration (OSHA) has specified the permissible noise level

exposures shown in the following chart:

Duration (hours) per day

SPL (dBA)

Typical Example

Duo in a small club

Subway

100

Very loud classical music

1.5

102

105

0.5

110

0.25 or less

115

Rock concert

WARNING:

Cancer and reproductive harm - www.p65warnings.ca.gov

PreSonus Compliance Information
European Union (EU)

The

CE mark

on this product indicates that the device is compliant with the

EU Council Directives

2014/35/EU

Low Voltage Directive

2014/30/EU

EMC Directive

For a copy of a specific product DoC, contact PreSonus at [email protected].

WEEE

This symbol on this product or its packaging indicates that this product must not be disposed of with other

waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated

collection point for the recycling of waste electrical and electronic equipment. The separate collection and recycling

of your waste equipment at the time of disposal will help conserve natural resources and ensure that it is recycled

in a manner that protects human health and the environment. For more information about where you can drop

off your waste equipment for recycling, please contact your local city recycling office or the dealer from whom you

purchased the product.

Radio and Television Interference

If these symbols are marked on the product, the device complies as follows:
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate

the equipment.

USA:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received, including interference that may cause

undesired operation. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed

in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures:
•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and the receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed

and operated with minimum distance 20cm between the radiator& your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

CAUTION:

Changes or modifications to this device not expressly approved by PreSonus Audio Electronics could void the user’s authority to

operate the equipment under FCC rules.

Australian Compliance:

This equipment complies with Radio communication Devices Notice 2003; or Radio communication

Labeling (Electromagnetic Compatibility) Notice 2008; or Radio communication (Compliance Labeling Electromagnetic

Radiation) Labeling Notice 2003.

IC WARNING
IC RSS warning:

This device complies with Industry Canada licence-exempt RSS standard (s). Operation is subject to the following two

conditions: (1) this device may not cause interference, and (2) this device must accept any interference,including interference that may

cause undesired operation of the device. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a

type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users,

the antenna type and its gain should be so chosen that, the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary

for successful communication.
This radio transmitter (identify the device by certifcation number, or model number if Category II) has been approved by Industry Canada

to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna

type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly

prohibited for use with this device.

IC Radiation Exposure Statement:

This equipment complies with IC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be

co-located or operating in conjunction with any other antenna or transmitter.
ICES003: This CAN ICES3 (B)/NMB3(B) digital apparatus complies with Canadian ICES003.

PreSonus Health, Safety, and Compliance Guide

Headphones

PreSonus Health, Safety, and Compliance Guide

Headphones

PreSonus Health, Safety, and Compliance Guide.

Part# 70-50000015-A

www.presonus.com