MACKIE MC-60BT Noise-Canceling Wireless Over-Ear Headphones - Manual (Page 7)

Owner
’s Manual
7
Owner’s Manual
MC-50BT • MC-60BT Features
First Things First
The MC-50BT and MC-60BT wireless headphones
were designed with sound and comfort in mind.
That said, for the best results, there are L/R markings
on the inside of the ear cushions/drivers to determine
each side. The power button is located on the left
(MC-60BT) and right (MC-50BT) headphone.
Warning: The headphones can be loud
and could cause permanent hearing
damage. Even intermediate levels
may be painfully loud. BE CAREFUL!
Always turn the volume all the way down before
putting on the headphones. Then turn it up slowly
as you listen carefully.
1. USB-C Power Connection
This connector is used for charging the wireless
headphones.
It is a standard USB-C power connector. Connect
the USB-C side of the detachable power cord
(included in the packaging) to the wireless
headphones and plug the other end of the power
cord into a standard USB-A connector.
A fully charged set of MC-50BT headphones
can last for up to 40+ hours of continuous usage.
A fully charged set of MC-60BT headphones
can last for up to 35+ hours of continuous usage...
and it takes only three hours for a completely dead
set of either to become fully charged once again.
Please note that the headphones
should not be used while charging.
2. Power / Bluetooth Button
Press and hold this button down to power
the headphones on and off. Voice prompts will
indicate the power on /off status, as well as
the connecting / paired status.
Upon powering up the wireless headphones,
the Bluetooth function is either:
(1) In sleep mode. See ‘Pairing and connecting
for the first time’ (below) or...
(2) ...Paired and connected. See ‘Previously paired
and connected devices’ (on the following page).
Pairing and connecting for the first time:
On the first power-up, a voice prompt will state,
“power on” followed by, “Bluetooth pairing mode”.
While the headphones are in pairing mode,
simultaneously scan for Bluetooth devices on
the computer or device. You should see ‘MC-50BT’
or ‘MC-60BT’ appear in the list of “available devices”.
Select it by tapping it. From there, your Bluetooth
device should indicate that it is successfully connected.
Two additional things will also occur. First, the status
LED will stop flashing blue and red and will begin
to slow flash blue [MC-50BT] or illuminate solid green
with a quick flash of blue[MC-60BT] instead. Second, a
voice prompt will say, “connected”.
If this does not work, start the pairing process again,
and make sure that the headphones and computer /
device are both in pairing mode at the same time.
MC-50BT MC-60BT
1 1 4 2 2/4 3 3
5
1
2
3
5
6
4
7
4
6