MACKIE MC-60BT Noise-Canceling Wireless Over-Ear Headphones - Manual (Page 10)

MC-
50B
T • MC-
60B
T W
ireles
s Headphones with W
ide-B
and Activ
e Noise Cancelling
10
MC-50BT • MC-60BT Wireless Headphones with Wide-Band Active Noise Cancelling
MC-50BT • MC-60BT Features continued...
MC-50BT MC-60BT
1 1 4 2 2/4 3 3
5
1
2
3
5
6
4
7
4
6
6. Right Earcup
The inside of the right earcup is for listening,
but the outside opens a world of possibilities.
Here you are able to swipe, tap and/or hold the right
earcup to pause/play, answer/end phone calls, go the
previous/next track, raise/lower the volume and more.
There are illustrations on the following page,
but the features are listed below, as well:
• Swipe up (towards headband): Raise volume.
• Swipe down (towards neck): Lower volume.
• Swipe forward (towards nose): Play next track.
• Swipe backward (towards back of head):
Play previous track.
• 2x Taps: Tapping the right side of the earcup
twice quickly will result in the music pausing/
playing. This is also the way to answer
and end phone calls.
• 3-Second Hold: Tapping (and holding) the right
side of the earcup down for three seconds
will result in the voice assistant making
an appearance.
• Palm Right Earcup [MC-50BT]: If you palm
the entire right earcup, the MC-50BT will
be put into momentary ambient mode.
It lowers the volume so you are able to hear
quick announcements, etc. without having
to pause the music or going into full ambient
mode .
7. Left Earcup [MC-60BT]
A charging pad is included with the MC-60BT
headphones for wireless charging.
The wireless charger is also a standard USB-C power
connector. Connect the USB-C side of the detachable
power cord (included in the packaging) to the wireless
charger and plug the other end of the power cord into
a standard USB-A connector.
The edge of the charger nearest the USB-C
connection will illuminate solid green to indicate power.
When the outside of the left earcup of the MC-60BT
headphones is placed on the center of the charger,
the full surrounding ring will illuminate and pulse green.
When fully charged, the pulsing ring turns solid green
and the status LED on the headphones changes from
solid red to solid green.
A fully charged set of MC-60BT headphones
can last for up to 35+ hours of continuous usage...
and it takes only five hours for a completely dead
set to become fully charged once again via the wireless
charger.
Please note that the headphones
should not be used while charging.
This might be difficult to believe, but, yes,
the MC-50BT headphones also have a left
earcup. Unfortunately, you can place it on
any wireless charger out there and nothing
will happen. It’s just for listening!
No, the wireless charger will indeed NOT heat
up (or cool down) any drinks. Please do
not set any drinks on the wireless charger
as it is not a coaster.
Care and Maintenance
Your wireless headphones will provide many years
of reliable service if you follow these simple guidelines:
• Avoid exposing them to moisture. If they will
be used outdoors, be sure they are under cover
if rain is expected.
• Use a dry cloth to clean the headphones. Only
do this when the power is turned off. Avoid getting
moisture into any of the openings of the headphones,
particularly where the drivers are located.