Austrian Audio Hi-X25BT Professional Wireless Bluetooth Over-Ear Headphones - Manual (Page 2)

Thank you for reading the instructions and thank you very much for putting your trust in Austrian
Audio.
Operating the Hi-X25BT:
Power on/off
Press the on/off button on the bottom of the right earcup for 2 seconds until your
Hi-X25BT welcomes you with a friendly “Power On” and the blue LED starts
blinking. If there is still an active connection, it will then automatically connect to
your previously connected device and will confirm this by indicating “Connected”
and the LED will change to glow continuously in blue.
To turn your headphones off, please press the on/off button for 3 seconds until your
Hi-X25BT turns off by indicating “Power Off” and the blue LED goes out.
Establish the Bluetooth®-connection
To establish a (new) connection, your headphones need to be turned off. Now
press the on/off button and continue pressing for 5 seconds. Your headphones
will turn on and automatically switch to the connecting mode, confirmed by
“Pairing” and a rapidly blinking blue LED.
Note: If you turn on your headphones for the first time, they will automatically
switch to the pairing mode.
Note: If your headphones cannot find a connection to your connecting device (e.g., because
Bluetooth® is deactivated on your device), your headphones will turn off automatically after
some time.
Charging and listening to audio in digital audio mode
Please use the included USB cable to charge your headphones. The
Bluetooth® connection will remain, and you can continue using the Hi-X25BT
while charging via USB cable.
If your Hi-X25BT is plugged in to a notebook for example, you can continue
to listen to music via the plugged in USB-cable while your headphones are
charging. To let your Hi-X25BT know that you want to switch from Bluetooth®
mode to digital audio mode, please press the on/off button briefly.
Note: Please note that the microphone is not available in USB digital audio mode.
If you want to change back from digital audio mode to Bluetooth® mode, simply press the
on/off button briefly again.